Makita DPC7001 Owner's Manual download pdf (Page 12)

PUTTING INTO OPERATION

Installing the drive arm and mounting the cutting

disc

CAUTION: Alwavs turn off the enqine before doing any

work on the drive arm or cutting disc. Pull the

plug cap off the spark plug. Wear protective

gloves!

CAUTION: Completely reassemble the Power Cut before

starting the engine!

Use the assembly

tool

delivered with the Power Cut (see page

6) for the following works.

Place the Power Cut on a stable surface and follow these steps

to install the drive arm and protection hood:

Turn the tightening screw

(B/4)

to the left (counter-clockwise)

until the pin

(B/5)

is at the left stop.

I-

Unscrew retaining nut (Ah).

Take off the sprocket guard (A/2) and unscrew the second

retaining nut (A/3).

NOTE:

The second retaining nut

(A/3)

protects against shipping

damage. It is located underneath thesprocket guard on the same

threaded pin as the first retaining nut.

Place the drive arm (C/6) over the two threaded pins (C/7)

and press towards the V-belt wheel (C/8).

Pull the V-belt (C/9) over the V-belt wheel.

Pull the hand guard (D/10) all the way forward and hold as

shown in Fig.

Press the drive arm onto the housing with both hands. Make

sure that the pin

(B/5)

fits into the space in the drive arm.

While continuing to hold the hand guard, put on the sprocket

guard

(E/2).

Screw on the retaining nuts (Ell) hand-tight.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Comments to this Manuals

No comments

Makita DPC7001 Owner's Manual Page 12

Comments to this Manuals