Makita DPC7001 Owner's Manual download pdf (Page 17)

MAINTENANCE

Changing theV-belt

Remove the cutting disc (see also “Cleaning the protective

hood”).

Loosen the knob (model 7000, 7001) or tightening toggle

(model 9500,9501) (D/3) somewhat and swing the protec-

tive hood (D/4) all the way back.

Loosen the retaining nuts (D/1) and screw (D/7) somewhat.

Loosen the tightening screw byturning it 2-3 turns

the left

(counter-clockwise) using the Allen key (D/5) supplied with

the Power Cut. This reduces the V-belt tension.

Remove the retaining nuts

(D/I)

and sprocket guard (D/2).

Turn the tightening screw to the left (counter-clockwise) all

the way.

Remove the cutter attachment (D/6).

Loosen and unscrew screws (E/8).

Pull

off the hand guard (E/9) and remove the guard plate

(E/10)

from the drive arm.

Remove the old V-belt

or V-belt

pieces. Clean

out

the inside

of the drive arm with a brush.

Fit a new V-belt

(E/11)

around the V-belt wheel (E/12) and

into the drive arm.

CAUTION: Before doing any workon the Power Cut turn

off

the engine, remove the cutting disc, pull the

plug cap off the spark plug and wear protective

gloves!

CAUTION: Completely reassemble the Power Cut before

starting the engine!

IMPORTANT:

Because many of the parts and assemblies not mentioned

in this Owner’s Manual arevital to the safety of the unit, and

because all parts are subject to a certain amount of wear and

tear, it is important for your own safety that you have the unit

checked and maintained regularly by a MAKITA service

center.

Fit on the guard plate and attach with screw (F/8)

Push the hand guard (F/9) all the way onto the drive arm and

tighten screw (FA 3) hand-tight.

install the drive arm and tighten the V-belt, see“1nstalling

the Drive Arm and Mounting the Cutting Disc”and “Tighten-

ing the V-Belt“.

Cleaning the protection hood

Over time, the inside of the protective hood can become caked

with material residue (especially from wet cutting), which if

allowed to accumulate can hinder the free rotation of the cutting

disc. For this reason the hood must be cleaned out from time to

time.

Removethecutting discandthesecond pressuredisc (G/14)

(on Model 9500,9501 there is an adapter ring (G/15) before

the pressure disc).

Clean out residue from the interior of the hood (G/16) using

a strip of wood or similar object

Clean the shaft (G/17) and all disassembled parts with a

cloth.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Comments to this Manuals

No comments

Makita DPC7001 Owner's Manual Page 17

Comments to this Manuals