Makita LS1211 Instruction Manual download pdf (Page 10)

Maintaining maximum cutting capacity

This tool

factory adjusted to provided the max. cutting capacity for

305 mm

(12”)

saw

blade. When using

saw blade other than the 305 mm

(12”)

saw blade, adjust the lower

limit position

the blade

follows:

First unplug the tool. Push the carriage toward the guide fence fully and lower the handle

completely. Use the socket wrench to turn the adjusting bolt until the periphery of the

blade extends slightly below the top surface of the turn base at the point where the front

face of the guide fence meets the top surface of the turn base. With the tool unplugged,

rotate the blade by hand while holding the handle

all

the way down to be sure that the

Periphery

blade

blade does not contact any part of the lower

base. Re-adjust slightly, if necessary.

surface

turn

base

turn

base

Guide fence

CAUTION

After installing

new blade, always

sure that the blade does not contact any Part of

the lower base when the handle

lowered completely.

Positioning

for

adjusting

the

miter angle

The turn base turns up to

60”

to the left

and right. Loosen the grip and turn the

turn base to the position where the pointer

points to the desired angle on the miter

scale. Then, tighten the grip firmly to secure

turn base.

-Miter scale

CAUTION

When turning the turn base,

sure

rasie

the handle fully.

After changing the miter angle, always secure the turn base by tightening the grip firmly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

Joe Finley 21 Jan 2024 | 19:04:28

Chsnge blade

Makita LS1211 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1211