Makita LS1211 Instruction Manual download pdf (Page 15)

Slide (push) cutting (cutting wide workpieces)

Workpieces up to

mm (3-1 1/16") high and 310 mm (12-3/16") wide or 107

(4-3/16") high and 290 mm

1-7/16") wide can be cut in the following way.

Loosen the clamp screw on the arm

that the carriage can slide freely. Secure the

workpiece with

vise.

Pull the carriage toward you fully. Switch on the tool and wait

until

the

blade attains full speed. Then

gently lower

the

handle to the fully

lowered position and PUSH THE

CARRIAGE TOWARD THE GUIDE

FENCE TO CUT THE WORKPIECE.

When

the

cut

completed, switch off

the tool and WAIT UNTIL THE

BLADE HAS COME TO A COMPLETE

STOP before returning the blade to

its

fully elevated position.

Holder assembly

(Optional accessory)

CAUTION:

Whenever performing the slide cut, FIRST PULL THE CARRIAGE TOWARD YOU

FULLY and press down the handle to the fully lowered position, then PUSH THE

CARRIAGE TOWARD THE GUIDE FENCE.

you

perform the slide cut without

pulling

the

carriage fully or if you perform the slide cut toward your direction, the

blade may kick back unexpectedly with

the

potential to cause serious injury.

Miter cutting

Bevel cut

Refer to the previously covered "Positioning for adjusting the miter angle".

Left and right

45" bevel cuts can be performed. At

left 45" bevel angle, work-

pieces up to

mm (1-7/8") high and 310 mm (12-3/16") wide or 57 mm (2-1/4")

high and 290 mm (1 1-7/16") wide can be cut. At

right

45"

bevel angle, workpieces

up to 31 mm (1-1/4") high and 310 mm (12-3/16") wide or 40 mm (1-9/16") high and

290 mm (11-7/16") wide can be cut.

Loosen the lever and

tilt

the saw blade to

set

the bevel angle. Be sure to re-tighten the

lever firmly to secure the selected bevel angle safely. Secure the worktiece with

vise.

Switch on the tool and wait until the

blade attains full speed. Then gently

lower the handle to the fully lowered

position while applying pressure in

parallel with the blade and PUSH THE

CARRIAGE TOWARD THE GUIDE

FENCE TO CUT THE WORKPIECE.

When the cut

completed, switch off

the tool and WAIT UNTIL THE

BLADE HAS COME

A COMPLETE

STOP before returning the blade to

its

fully elevated position.

Apply pressure in

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Comments to this Manuals

Joe Finley 21 Jan 2024 | 19:04:28

Chsnge blade

Makita LS1211 Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1211