Makita LS1211 Instruction Manual download pdf (Page 14)

Operation

CAUTION

.Make sure the blade

not contacting the workpiece,

etc.

before the switch

turned on.

not apply excessive pressure on the handle when cutting. Too much force may result

in overload of the motor and/or decreased cutting efficiency.

*Gently press down the handle to perform the cut. If the handle

pressed down with

force or if lateral force

applied, the blade will vibrate and

leave

mark (saw mark) in

the workpiece and the precision of the cut will be impaired.

During

slide cut, gently push the carriage toward the guide fence without stopping. If

the carriage movement

stopped during the cut,

mark will be left in the workpiece and

the precision of the cut will be impaired.

Press cutting (cutting

small

workpieces)

Workpieces up to 94 mm (3-1 1/16")

high and 130 mm

(5-1/8")

wide or

107

(4-3/16") high and 110 mm (4-5/16") wide can be cut in the following way.

Push the carriage toward the guide

fence fully and tighten the clamp screw

on the arm to secure the carriage in the

"back" position. Secure the workpiece

with

vise.

Switch on the tool and wait

until the blade attains full speed before

lowering gently into the cut. When the

cut

completed, switch off the tool

and WAIT UNTIL THE BLADE HAS

COME

A COMPLETE STOP be-

fore returning the blade to

its

fully

eva

ted posit ion.

Lower

gently

CAUTION:

Firmly tighten the clamp screw on the arm

that the carriage will not move during

operation. Insufficient tightening may cause unexpected kickback of the blade. Possible

serious injury may result.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comments to this Manuals

Joe Finley 21 Jan 2024 | 19:04:28

Chsnge blade

Makita LS1211 Instruction Manual Page 14

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1211