Makita LS1211 Instruction Manual download pdf (Page 12)

Securing workpiece

WARNING:

extremely important to always secure the workpiece properly and tightely with the

vise.

Failure to do

can cause the tool to be damaged and/or the workpiece to be des-

troyed. PERSONAL INJURY MAY ALSO RESULT. Also, after any cutting operation,

NOT raise the blade until the blade

has

come to

complete stop.

Vertical

vise

The vertical vise can be installed in two

positions on either the left or right side

of the guide fence, or holder assembly

(optional accessory). Insert the

vise

rod

into the hole in the guide fence or holder

assembly and tighten

the

screw to secure

the vise rod. (Note: When using the

holder assembly, install

on the holder

(optional accessory)

shown in the

figure.) Position the vise arm according

to the thickness and shape of the work-

piece and secure the

vise

arm by tighten-

ing the screw. Make sure that

part of

Holder

Hkr

assembly

the tool contacts the

vise

when lowering th. handle fully or when pulling or pushing

the carriage. If some part contacts the

vise,

re-position the

vise.

Press

the

workpiece flat

against the guide fence and the turn base. Position the workpiece

the desired cutting

position and secure

firmly by tightening

the

clamp screw of

the

vise.

The maximum

thickness of workpieces which can be secured by the vertical

vise

120 mm

(4-3/4").

CAUTION

The workpiece must always be secured firmly against the turn base and guide fence with

the

vise

during all operations.

Horizontal

vise

(optional acccssory)

The horizontal vise can be installed in

two positions

either the left or right

side of the base. When performing

15"

greater miter cuts, install

the

horizontal

vise

the side opposite the direction in

which the turn table

to be turned.

flipping the

vise

nut to the left, the

vise

is released, and rapidly moves

and out.

To grip workpieces, push the

vise

knob

forward until the

vise

plate contacts the

workDiece and fliD the

vise

nirt to the

right.' Then turn the

vise

knob clockwise to secure the workpiece. The maximum width

of workpieces which can be secured by the horizontal

vise

200

(7-7/8").

CAUTION

Always

set

the vise nut to the right fully when securing the workpiece. Failure to do

may result in insufficient securing of the workpiece. This could cause the workpiece to

be thrown, cause damage to the blade or cause the dangerous

loss

of control of the tool.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Comments to this Manuals

Joe Finley 21 Jan 2024 | 19:04:28

Chsnge blade

Makita LS1211 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1211