Makita LS0815FL Instruction Manual

1 INSTRUCTION MANUAL MANUEL D'INSTRUCTION MANUAL DE INSTRUCCIONES DOUBLE INSULATION DOUBLE ISOLATION DOBLE AISLAMIENTO IMPORTANT: Read Before

10 1 014274 To turn on the light, press the upper position (ON) of the switch. To turn off the light, press the lower position (OFF) of the switch.

11 flanges. Use of the incorrect arbor hole ring may result in the improper mounting of the blade causing blade movement and severe vibration resultin

12 12 001549 Guide fence (SLIDING FENCES) adjustment 12 014278 CAUTION: • Before operating the tool, make sure that the sliding fence is secured fi

13 accurate cut and to prevent dangerous loss of tool control. Proper workpiece support will help avoid blade pinch and possible kickback which may re

14 WARNING: • Whenever performing a slide cut, first pull the carriage full towards you and press the handle all the way down, then push the carriage

15 123 001555 There are crown and cove molding joints which are made to fit "Inside" 90° corners ((1) and (2) in Fig. A) and "Outside&

16 CeilingWall30.1 29.7 29.4 29.0 28.7 28.3 28.0 27.6 27.2 26.9 26.5 26.1 25.8 25.4 25.0 24.7 24.3 23.9 23.6 23.2 22.8 22.5 22.1 21.7 21.3 21.0 20.6 2

17 26.726.426.125.825.525.224.924.624.223.923.623.323.022.722.322.021.721.421.020.720.420.019.719.419.118.718.418.117.717.417.116.716.416.015.715.415.

18 7. Cutting aluminum extrusion 12345 010404 When securing aluminum extrusions, use spacer blocks or pieces of scrap as shown in the figure to prev

19 Make sure that the tool is unplugged. Secure the blade at 0° bevel angle and the turn base at the full right miter angle position. Secure the slide

2 ENGLISH (Original instructions) SPECIFICATIONS Model LS0815F /LS0815FL Blade diameter 216 mm (8-1/2") Hole diameter 15.88 mm (5/8") Max

20 2. Bevel angle (1) 0° bevel angle 12 014299 Push the carriage toward the guide fence and tighten the locking screw to secure the carriage. Lower

21 Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 12 010256 After replacing brushes, plug in the tool and br

3 12. SECURE WORK. Use clamps or a vise to hold work when practical. It's safer than using your hand and it frees both hands to operate tool. 13

4 USB036-3 ADDITIONAL SAFETY RULES DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to slide compoun

5 30. Do not abuse cord. Never yank cord to disconnect it from the receptacle. Keep cord away from heat, oil, water and sharp objects. 31. NEVER sta

6 FUNCTIONAL DESCRIPTION WARNING: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Fa

7 NOTICE: • After setting the bevel angle ensure that the kerf boards are adjusted properly. Correct adjustment of the kerf boards will help provide

8 To adjust the bevel angle, loosen the lever at the rear of the tool counterclockwise. Unlock the arm by pushing the handle somewhat strongly in the

9 result in unintentional operation and serious personal injury. Return tool to a Makita service center for proper repairs BEFORE further usage. • NE