Makita LS1016 Instruction Manual download pdf (Page 20)

009521

009522

Fig. B: At right 45° miter angle

Fig. C: At left 45° miter angle

Position crown molding with its WALL CONTACT

EDGE against the guide fence and its CEILING

CONTACT EDGE against the crown molding

stoppers as shown in the figure. Adjust the crown

molding stoppers according to the size of the crown

molding. Tighten the screws to secure the crown

molding stoppers. Refer to the table (C) for the

miter angle.

009520

Position in

Fig. A

Miter angle Finished piece

(1) Right 45° Save the right side of blade

(2) Save the left side of blade

(3) Save the right side of blade

(4) Right 45° Save the left side

of blade

Left 45°

For inside

corner

For outside

corner

Table (C)

006365

7. Cutting aluminum extrusion

009523

When securing aluminum extrusions, use spacer

blocks or pieces of scrap as shown in the figure to

prevent deformation of the aluminum. Use a cutting

lubricant when cutting the aluminum extrusion to

prevent build-up of the aluminum material on the

blade.

WARNING:

• Never attempt to cut thick or round aluminum

extrusions. Thick or round aluminum extrusions

can be difficult to secure and may work loose

during the cutting operation which may result in

loss of control and serious personal injury.

8. Groove cutting

001563

A dado type cut can be made by proceeding as

follows:

Adjust the lower limit position of the blade using the

adjusting screw and the stopper arm to limit the

cutting depth of the blade. Refer to "Stopper arm"

section described previously.

After adjusting the lower limit position of the blade,

cut parallel grooves across the width of the

workpiece using a slide (push) cut as shown in the

figure. Then remove the workpiece material

between the grooves with a chisel.

WARNING:

• Do not attempt to perform this type of cut by

using a wider type blade or dado blade.

Attempting to make a groove cut with a wider blade

or dado blade could lead to unexpected cutting

results and kickback which may result in serious

personal injury

1. Cut grooves with

blade

1. Guide fence

2. Vise

3. Spacer block

4. Aluminum

extrusion

5. Spacer block

1. Guide fence

2. Crown molding

1. Crown molding

stopper L

2. Crown molding

stopper R

3. Turn base

1. Crown molding

stopper L

(Optional

accessory)

2. Crown molding

stopper R

(Optional

accessory)

3. Turn base

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments

Makita LS1016 Instruction Manual Page 20

Comments to this Manuals

Related products and manuals for Circular saws Makita LS1016