Makita LS1016 Instruction Manual download pdf (Page 24)

Cleaning the laser light lens

For model LS1016L only

009609

If the lens for the laser light becomes dirty, or sawdust

adheres to it in such a way that the laser line is no longer

easily visible, unplug the saw and remove and clean the

lens for the laser light carefully with a damp, soft cloth.

Do not use solvents or any petroleum-based cleaners on

the lens.

009610

To remove the lens for the laser light, remove the saw

blade before removing the lens according to the

instructions in the section titled "Installing or removing

saw blade".

Loosen but do not remove the screw which secures the

lens using a screwdriver.

Pull out the lens as shown in the figure.

NOTE:

• If the lens does not come out, loosen the screw

further and pull out the lens again without removing

the screw.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps.

009516

After replacing brushes, plug in the tool and break in

brushes by running tool with no load for about 10 minutes.

Then check the tool while running and electric brake

operation when releasing the switch trigger. If the electric

brake is not working correctly, have the tool repaired by a

Makita service center

After use

• After use, wipe off chips and dust adhering to the

tool with a cloth or the like. Keep the blade guard

clean according to the directions in the previously

covered section titled "Blade guard". Lubricate the

sliding portions with machine oil to prevent rust.

• When storing the tool, pull the carriage toward you

fully so that the slide pole is thoroughly inserted into

the turn base.

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be

performed by Makita Authorized or Factory Service

Centers, always using Makita replacement parts.

ACCESSORIES

WARNING:

• These Makita accessories or attachments are

recommended for use with your Makita tool

spcified in this manual. The use of any other

accessories or attachments may result in serious

personal injury.

• Only use the Makita accessory or attachment

for its stated purpose. Misuse of an accessory or

attachment may result in serious personal injury.

If you need any assistance for more details regarding

these accessories, ask your local Makita Service Center.

• Steel & Carbide-tipped saw blades

1. Screwdriver

2. Brush holder cap

1. Limit mark

1. Lens for the

laser light

1. Screwdriver

2. Screw (one

piece only)

3. Lens for the

laser light

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

Comments to this Manuals

No comments

Makita LS1016 Instruction Manual Page 24

Comments to this Manuals

Related products and manuals for Circular saws Makita LS1016