Makita LS1016 Instruction Manual download pdf (Page 13)

009611

In case of bevel-cutting, adjust the lower and upper fence

positions to be as close to the blade as practical to

provide maximum workpiece support, and make sure

that no part of the tool, especially the blade, contacts the

lower and upper fences when lowering and raising the

handle fully at any position and pulling or pushing the

carriage all the way at the lowest position.

Before cutting operations, make a dry run with the saw

turned off and unplugged, then check clearance between

fences and moving parts.

Before cutting operations, firmly secure lower fences by

tightening the clamping screws and upper fences by

tightening the levers.

When bevel-cutting operations are complete, don't forget

to return the upper fences to the original position and

return it.

Vertical vise

009502

The vertical vise can be installed in two positions on

either the left or right side of the base. Insert the vise rod

into the hole in the base.

Position the vise arm according to the thickness and

shape of the workpiece and secure the vise arm by

tightening the screw. If the screw to secure the vise arm

contacts the carriage, install the screw on the opposite

side of vise arm. Make sure that no part of the tool

contacts the vise when lowering the handle fully and

pulling or pushing the carriage all the way. If some part

contacts the vise, re-position the vise.

Press the workpiece flat against the guide fence and the

turn base. Position the workpiece at the desired cutting

position and secure it firmly by tightening the vise knob.

Turning the vise knob to 90° counterclockwise allows the

vise knob to be moved up and down, facilitating the quick

setting of workpiece. To secure the workpiece after

setting, turn the vise knob clockwise.

WARNING:

• The workpiece must be secured firmly against

the turn base and guide fence with the vise

during all operations. If the workpiece is not

properly secured against the fence the material

may move during the cutting operation causing

possible damage to the blade, causing the material

to be thrown and loss of control resulting in serious

personal injury.

Horizontal vise (optional accessory)

009606

The horizontal vise can be installed in two positions on

either the left or right side of the base. When performing

15° or greater miter cuts, install the horizontal vise on the

side opposite the direction in which the turn base is to be

turned.

005232

By flipping the vise nut counterclockwise, the vise is

released, and rapidly moves in and out. To grip the

workpiece, push the vise knob forward until the vise plate

contacts the workpiece and flip the vise nut clockwise.

Then turn the vise knob clockwise to secure the

workpiece.

The maximum width of workpiece which can be secured

by the horizontal vise is 215 mm (8-1/2").

WARNING:

• Always rotate the vise nut clockwise until the

workpiece is properly secured. If the workpiece

is not properly secured the material may move

during the cutting operation causing possible

damage to the blade, causing the material to be

thrown and loss of control resulting in serious

personal injury.

1. Vise plate

2. Vise nut

3. Vise knob

1. Vise knob

2. Vise arm

3. Vise rod

4. Screw

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Comments to this Manuals

No comments

Makita LS1016 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Circular saws Makita LS1016