Makita HM1214C Use and Care Manual download pdf (Page 6)

010077

After installing, always make sure that the bit is securely

held in place by trying to pull it out.

To remove the bit, pull the releasing cover down all the

way and pull the bit out.

009974

Bit angle

009975

The bit can be secured at 12 different angles. To change

the bit angle, slide the change ring cover forward, then

turn the change ring cover to change the bit angle. At the

desired angle, slide the change ring cover back to the

original position. The bit will be secured in place.

OPERATION

Chipping/Scaling/Demolition

009980

Always use the side grip (auxiliary handle) and firmly

hold the tool by both side grip and switch handle during

operations. Turn the tool on and apply slight pressure on

the tool so that the tool will not bounce around,

uncontrolled. Pressing very hard on the tool will not

increase the efficiency.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

Lubrication

CAUTION:

• This servicing should be performed by Makita

Authorized or Factory Service Centers only.

This tool requires no hourly or daily lubrication because

it has a grease-packed lubrication system. However, it is

recommended to periodically replace the grease for

longer tool life.

First, switch off and unplug the tool.

010076

Remove the six hex socket head bolts using a hex

wrench and remove the rear cover.

010075

Pull out the filter case in the direction of arrow and

remove it.

1. Change ring

cover

1. Rear cover

2. Hex wrench 5

1. Filter case

1. Releasing cover

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Makita HM1214C Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita HM1214C