Makita 3708 User Manual download pdf (Page 7)

NOTE:

• The workpiece will be cut a slightly different size

from the templet. Allow for the distance (X) between

the router bit and the outside of the templet guide.

The distance (X) can be calculated by using the fol-

lowing equation:

Distance (X) = (outside diameter of the templet guide -

router bit diameter) / 2

Straight guide (Accessory)

The straight guide is effectively used for straight cuts

when chamfering or grooving.

Attach the guide plate to the straight guide with the bolt,

the wave washer, the flat washer and the wing nut.

Loosen the wing bolts and secure the tool base horizon-

tally. Attach the straight guide with the clamp screw (A).

Loosen the wing nut on the straight guide and adjust the

distance between the bit and the straight guide. At the

desired distance, tighten the wing nut securely.

When cutting, move the tool with the straight guide flush

with the side of the workpiece.

If the distance (A) between the side of the workpiece and

the cutting position is too wide for the straight guide, or if

the side of the workpiece is not straight, the straight

guide cannot be used. In this case, firmly clamp a

straight board to the workpiece and use it as a guide

against the trimmer base. Feed the tool in the direction of

the arrow.

Circular work

Circular work may be accomplished if you assemble the

straight guide and guide plate as shown in the figures.

Min. and max. radius of circles to be cut (distance

between the center of circle and the center of bit) are as

follows:

Min.: 70 mm (2-3/4”)

Max.: 221 mm (8-11/16”)

For cutting circles between 70 mm (2-3/4”) and 121 mm

(4-3/4”) in radius.

For cutting circles between 121 mm (4-3/4”) and 221 mm

(8-11/16”) in radius.

NOTE:

• Circles between 172 mm (6-3/4”) and 186 mm (7-5/

16”) in radius cannot be cut using this guide.

Align the center hole in the straight guide with the center

of the circle to be cut. Drive a nail less than 6 mm (1/4”)

in diameter into the center hole to secure the straight

guide. Pivot the tool around the nail in clockwise direc-

tion.

1. Bolt

2. Guide plate

3. Straight guide

4. Flat washer

5. Wave washer

6. Wing nut

1. Clamp screw

(A)

2. Straight guide

3. Wing bolt

4. Base

5. Wing nut

001989

001990

002008

1. Wing nut

2. Wave washer

3. Flat washer

4. Guide plate

5. Straight guide

6. Center hole

7. Bolt

1. Wing nut

2. Wave washer

3. Flat washer

4. Guide plate

5. Straight guide

6. Center hole

7. Bolt

002009

001993

001994

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Makita 3708 User Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Makita 3708