Makita 6213D Specifications download pdf (Page 11)

CAUTION:

• Always set the speed change lever fully to the correct

position. If you operate the tool with the speed change

lever positioned halfway between the “I” side and “II”

side, the tool may be damaged.

• Do not use the speed change lever while the tool is

running. The tool may be damaged.

Adjusting the fastening torque

The fastening torque can be adjusted in 18 steps by turning

the adjusting ring so that its graduations are aligned with the

pointer on the tool body. The fastening torque is minimum

when the number 1 is aligned with the pointer, and maximum

when the marking is aligned with the pointer.

The clutch will slip at various torque levels when set at the

number 1 to 5. The clutch is designed not to slip at the

marking.

Before actual operation, drive a trial screw into your material

or a piece of duplicate material to determine which torque

level is required for a particular application.

NOTE:

• The adjusting ring does not lock when the pointer is

positioned only halfway between the graduations.

• Do not operate the tool with the adjusting ring set

between the number 5 and the marking. The tool may

be damaged.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out any

work on the tool.

Installing or removing driver bit or drill bit

Hold the ring and turn the sleeve counterclockwise to open

the chuck jaws. Place the bit in the chuck as far as it will go.

Hold the ring firmly and turn the sleeve clockwise to tighten

the chuck.

To remove the bit, hold the ring and turn the sleeve counter-

clockwise.

1. Adjusting ring

2. Drill marking

3. Pointer

4. Graduations

002102

1. Sleeve

2. Ring

3. Tighten

002116

1 ... 10 11 12 ... 20

Comments to this Manuals

No comments

Makita 6213D Specifications Page 11

Comments to this Manuals

Related products and manuals for Power drills Makita 6213D