Makita HR3200C Instruction Manual download pdf (Page 7)

action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque

level is reached. The motor will disengage from the

output shaft. When this happens, the bit will stop turning.

CAUTION:

• As soon as the torque limiter actuates, switch off

the tool immediately. This will help prevent

premature wear of the tool.

Indicator lamp

008541

The green power-ON indicator lamp lights up when the

tool is plugged. If the indicator lamp does not light up,

the mains cord or the controller may be defective. The

indicator lamp is lit but the tool does not start even if the

tool is switched on, the carbon brushes may be worn out,

or the controller, the motor or the ON/OFF switch may be

defective.

The red service indicator lamp lights up when the carbon

brushes are nearly worn out to indicate that the tool

needs servicing. After approx. 8 hours of use, the motor

will automatically be shut off.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Side grip

008542

CAUTION:

• Always use the side grip to ensure operating safety

when drilling in concrete, masonry, etc.

The side grip swings around to either side, allowing easy

handling of the tool in any position. Loosen the side grip

by turning it counterclockwise, swing it to the desired

position and then tighten it by turning clockwise.

Installing or removing the bit

003150

Clean the bit shank and apply bit grease before installing

the bit.

Insert the bit into the tool. Turn the bit and push it in until

it engages.

008543

If the bit cannot be pushed in, remove the bit. Pull the

chuck cover down a couple of times. Then insert the bit

again. Turn the bit and push it in until it engages.

After installing, always make sure that the bit is securely

held in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way

and pull the bit out.

008544

1. Bit

2. Chuck cover

1. Bit

2. Chuck cover

1. Bit shank

2. Bit grease

1. Side grip

1. Power-ON

indicator lamp

(green)

2. Service indicator

lamp (red)

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR3200C Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR3200C