Makita HR3200C Instruction Manual

1 ENGLISH INSTRUCTION MANUAL DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUT

10 Lubrication CAUTION: • This servicing should be performed by Makita Authorized or Factory Service Centers only. This tool requires no hourly or d

11 To reassemble the tool, follow the disassembling procedure in reverse. CAUTION: • Do not tighten the crank cap excessively. It is made of resin

12 Makita Corporation Anjo, Aichi, Japan 884769-228

2 ENGLISH SPECIFICATIONS Model HR3200C HR3210C HR3210FCT Tungsten-carbide tipped bit 32 mm Concrete Core bit 90 mm Steel 13 mm Capacities Wood 32 mm

3 ENG215-1 Vibration The vibration total value (tri-axial vector sum) determined according to EN60745-2-6: Work mode : chiseling function Vibration em

4 10. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the

5 used for a long time, let the tool warm up for a while by operating it under no load. This will loosen up the lubrication. Without proper warm-up, h

6 • The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer

7 action mode positions. Torque limiter The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the out

8 Bit angle (when chipping, scaling or demolishing) 123 008545 The bit can be secured at 24 different angles. To change the bit angle, depress the l

9 After drilling the hole, use the blow-out bulb to clean the dust out of the hole. Chipping/Scaling/Demolition 008548 Set the change lever to the