Makita HR3200C Instruction Manual download pdf (Page 8)

Bit angle (when chipping, scaling or

demolishing)

008545

The bit can be secured at 24 different angles. To change

the bit angle, depress the lock button and rotate the

change lever so that the pointer points to the

symbol.

Turn the bit to the desired angle.

Depress the lock button and rotate the change lever so

that the pointer points to the

symbol. Then make sure

that the bit is securely held in place by turning it slightly.

Depth gauge

008546

The depth gauge is convenient for drilling holes of

uniform depth. Loosen the clamp screw and adjust the

depth gauge to the desired depth. After adjusting,

tighten the clamp screw firmly.

NOTE:

• The depth gauge cannot be used at the position

where the depth gauge strikes against the gear

housing/motor housing.

Dust cup

001300

Use the dust cup to prevent dust from falling over the

tool and on yourself when performing overhead drilling

operations. Attach the dust cup to the bit as shown in the

figure. The size of bits which the dust cup can be

attached to is as follows.

Bit diameter

Dust cup 5 6 mm - 14.5 mm

Dust cup 9

12 mm - 16 mm

006406

OPERATION

Hammer drilling operation

008547

Set the change lever to the

symbol.

Position the bit at the desired location for the hole, then

pull the switch trigger. Do not force the tool. Light

pressure gives best results. Keep the tool in position and

prevent it from slipping away from the hole.

Do not apply more pressure when the hole becomes

clogged with chips or particles. Instead, run the tool at

an idle, then remove the bit partially from the hole. By

repeating this several times, the hole will be cleaned out

and normal drilling may be resumed.

CAUTION:

• When the bit begins to break through concrete or if

the bit strikes reinforcing rods embedded in

concrete, the tool may react dangerously. Maintain

good balance and safe footing while holding the

tool firmly with both hands to prevent dangerous

reaction.

Blow-out bulb (optional accessory)

002449

1. Blow-out bulb

1. Dust cup

1. Depth gauge

2. Clamp screw

1. Change lever

2. Lock button

3. Pointer

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR3200C Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR3200C