Makita DCS 520i Service Manual download pdf (Page 18)

PUlTlNG INTO OPERATION

Mounting the guide bar and saw chain

Use the universal wrench delivered with the chain saw for the

following work.

Put the chain saw on a stable surface and carry out the

following steps for mounting the guide bar and chain:

CAUTION:

Before doing any work on the guide bar or

chain. Mys switch

off

the engine and pull

the plug cap

off

the spark plug (see 'Replacing

thespark plug"). Always wear protectivegloves!

CAUTION:

Start

the chain saw only after having assem-

bled

completely and inspected!

Always release the chain brake before removing or replac-

ing the sprocket guard

(W4).

To do

so.

pull the hand guard

(Nl)

towards the tubular handle

(N2)

until you feel it catch.

Unscrew retaining nuts

(813).

Pull

off

the sprocket guard

(814).

Turn the chain adjusting screw.(C/6)

the left (counter-

clockwise) until the pin (Cn) is at the left stop.

Lift the chain

(U10)

over the clutch drum and onto the

sprocket

(Vll).

Usingyour right hand, guide the chain into

the top guide groove on the guide bar

(W8).

NOTE:

The cutting edges along the top of the chain must

point in the direction of the arrow!

Position the guide bar

(We).

Make sure that the pin

(D19)

the chain tightener is in the hofe (circled) on the guide bar.

Lead the chain

(F/lO)

around the sprocket nose

(F/12)

the guide bar.

NOTE:

The chain should be easy

pull in the direction of the

arrow.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comments to this Manuals

No comments

Makita DCS 520i Service Manual Page 18

Comments to this Manuals

Related products and manuals for Power chainsaws Makita DCS 520i