Makita LS711D Specifications download pdf (Page 20)

1. Press cutting (cutting small workpieces)

Workpieces up to 50 mm (2”) high and 97 mm (3-13/16”)

wide can be cut in the following way.

Push the carriage toward the guide fence fully and

tighten the clamp screw on the turn base clockwise to

secure the carriage. Secure the workpiece with the vise.

Switch on the tool without the blade making any contact

and wait until the blade attains full speed before lower-

ing. Then gently lower the handle to the fully lowered

position to cut the workpiece. When the cut is com-

pleted, switch off the tool and WAIT UNTIL THE BLADE

HAS COME TO A COMPLETE STOP before returning

the blade to its fully elevated position.

CAUTION:

• Firmly tighten the clamp screw on the turn base

clockwise so that the carriage will not move during

operation. Insufficient tightening may cause unexpected

kickback of the blade. Possible serious PERSONAL

INJURY may result.

2. Slide (push) cutting (cutting wide workpieces)

Loosen the clamp screw on the turn base counterclock-

wise so that the carriage can slide freely. Secure the

workpiece with the vise. Pull the carriage toward you

fully. Switch on the tool without the blade making any

contact and wait until the blade attains full speed. Press

down the handle and PUSH THE CARRIAGE TOWARD

THE GUIDE FENCE AND THROUGH THE WORK-

PIECE. When the cut is completed, switch off the tool

and WAIT UNTIL THE BLADE HAS COME TO A COM-

PLETE STOP before returning the blade to its fully ele-

vated position.

CAUTION:

• Whenever performing the slide cut, FIRST PULL THE

CARRIAGE TOWARD YOU FULLY and press down the

handle to the fully lowered position, then PUSH THE

CARRIAGE TOWARD THE GUIDE FENCE. NEVER

START THE CUT WITH THE CARRIAGE NOT FULLY

PULLED TOWARD YOU. If you perform the slide cut

without pulling the carriage fully or if you perform the

slide cut toward your direction, the blade may kickback

unexpectedly with the potential to cause serious

PERSONAL INJURY.

002218

002219

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments

Makita LS711D Specifications Page 20

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS711D