Makita LS711D Specifications download pdf (Page 4)

18. NEVER STAND ON TOOL. Serious injury

could occur if the tool is tipped or if the

cutting tool is unintentionally contacted.

19. CHECK DAMAGED PARTS. Before further

use of the tool, a guard or other part that

is damaged should be carefully checked

to determine that it will operate properly

and perform its intended function - check

for alignment of moving parts, binding of

moving parts, breakage of parts, mount-

ing, and any other conditions that may

affect its operation. A guard or other part

that is damaged should be properly

repaired or replaced.

20. DIRECTION OF FEED. Feed work into a

blade or cutter against the direction of

rotation of the blade or cutter only.

21. NEVER LEAVE TOOL RUNNING UNAT-

TENDED. TURN POWER OFF. Don’t leave

tool until it comes to a complete stop.

ADDITIONAL SAFETY RULES USB033-2

DO NOT let comfort or familiarity with product (gained from

repeated use) replace strict adherence to slide compound saw

safety rules. If you use this tool unsafely or incorrectly, you can

suffer serious personal injury.

1. Wear eye protection.

2. Keep hands out of path of saw blade.

Avoid contact with any coasting blade. It

can still cause severe injury.

3. Do not operate saw without guards in

place. Check blade guard for proper clos-

ing before each use. Do not operate saw if

blade guard does not move freely and

close instantly. Never clamp or tie the

blade guard into the open position.

4. Do not perform any operation freehand.

The workpiece must be secured firmly

against the turn base and guide fence with

a vise during all operations. Never use

your hand to secure the workpiece.

5. Never reach around saw blade.

6. Turn off tool and wait for saw blade to

stop before moving workpiece or chang-

ing settings.

7. Remove battery from tool before changing

blade or servicing.

8. To reduce the risk of injury, return car-

riage to the full rear position after each

crosscut operation.

9. Always secure all moving portions before

carrying the tool.

10. Stopper pin which locks the cutter head

down is for carrying and storage pur-

poses only and not for any cutting opera-

tions.

11. Be aware that this tool is always in an

operating condition, because it does not

have to be plugged into an electrical out-

let.

12. Do not use the tool in the presence of

flammable liquids or gases.

13. Check the blade carefully for cracks or

damage before operation. Replace

cracked or damaged blade immediately.

Gum and wood pitch hardened on blades

slows saw and increases potential for

kickback. Keep blade clean by first remov-

1 2 3 4 5 6 7 8 9 ... 35 36

Comments to this Manuals

No comments

Makita LS711D Specifications Page 4

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS711D