Makita LS1040F Instruction Manual download pdf (Page 15)

0° bevel angle adjusting bolt

counterclockwise. Then tighten the hex nut to

secure the 0° bevel angle adjusting bolt and

tighten the lever securely.

010798

Make sure that the pointer on the turn base

point to 0° on the bevel scale on the arm. If it

does not point to 0°, loosen the screw which

secures the pointer and adjust the pointer so

that it will point to 0°.

001769

(2) 45° bevel angle

001770

Adjust the 45° bevel angle only after

performing 0° bevel angle adjustment. To

adjust left 45° bevel angle, loosen the lever

and tilt the blade to the left fully. Make sure

that the pointer on the arm points to 45° on

the bevel scale on the arm holder. If the

pointer does not point to 45°, turn the 45°

bevel angle adjusting bolt on the left side of

the arm until the pointer points to 45°.

Replacing fluorescent tube

002028

CAUTION:

• Always be sure that the tool is switched off and

unplugged before replacing the fluorescent tube.

• Do not apply force, impact or scratch to a

fluorescent tube, which can cause a glass of the

fluorescent tube to be broken resulting in a injury to

you or your bystanders.

• Leave the florescent tube for a while immediately

after a use of it and then replace it. If not. You may

burn yourself.

Remove screws, which secure Lamp Box for the light.

Pull out the Lamp Box keeping pushing lightly the upper

position of it as illustrated on the left.

Pull out the fluorescent tube and then replace it with

Makita original new one.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps.

1. Limit mark

1. Pull out

2. Push

3. Lamp box

4. Screws

5. Fluorescent tube

1. Lever

2. Arm

3. Pointer

4. 45 󺺨 bevel angle

adjusting bolt

1. Arm

2. Bevel scale

3. Pointer

4. Turn base

1. Triangular rule

2. Saw blade

3. Top surface of

turn base

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Makita LS1040F Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1040F