Makita LS1040F Instruction Manual download pdf (Page 2)

ENGLISH (Original instructions)

SPECIFICATIONS

Model LS1040F / LS1040FS

Blade diameter 255 mm - 260 mm

Blade body thickness 1.6 mm - 2.4 mm

Hole diameter

For all countries other than European countries 25.4 mm and 25 mm

For European countries 30 mm

Max. Miter angle Left 45° , Right 52°

Max. Bevel angle Left 45°

Max. Cutting capacities (H x W) with blade 260 mm in diameter

Miter angle

Bevel angle

0° 45° (left and right)

93 mm x 95 mm 93 mm x 67 mm

0°

69 mm x 135 mm 69 mm x 95 mm

53 mm x 95 mm 49 mm x 67 mm

45° (left)

35 mm x 135 mm 35 mm x 94 mm

No load speed (min

-1

) 4,600

Dimensions (L x W x H) 530 mm x 476 mm x 532 mm

Net weight 12.6 kg

Safety class

/II

• Due to our continuing program of research and development, the specifications herein are subject to change without notice.

• Specifications may differ from country to country.

• Weight according to EPTA-Procedure 01/2003

END217-5

Symbols

The following show the symbols used for the equipment.

Be sure that you understand their meaning before use.

󺹮 Read instruction manual.

󺹮 DOUBLE INSULATION

󺹮 To avoid injury from flying debris, keep

holding the saw head down, after

making cuts, until the blade has come to

a complete stop.

󺹮 Do not place hand or fingers close to the

blade.

󺹮 For your safety, remove the chips, small

pieces, etc. from the table top before

operation.

󺹮 Always set SUB-FENCE to left position

when performing left bevel cuts. Failure

to do so may cause serious injury to

operator.

󺹮 To loosen the bolt, turn it clockwise.

󺹮 Only for EU countries

Do not dispose of electric equipment

together with household waste material!

In observance of the European Directive,

on Waste Electric and Electronic

Equipment and its implementation in

accordance with national law, electric

equipment that have reached the end of

their life must be collected separately

and returned to an environmentally

compatible recycling facility.

ENE004-1

Intended use

The tool is intended for accurate straight and miter

cutting in wood. With appropriate saw blades, aluminum

can also be sawed.

ENF002-2

Power supply

The tool should be connected only to a power supply of

the same voltage as indicated on the nameplate, and can

only be operated on single-phase AC supply. They are

double-insulated and can, therefore, also be used from

sockets without earth wire.

1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments

Makita LS1040F Instruction Manual Page 2

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1040F