Makita LS1040F Instruction Manual download pdf (Page 11)

001549

Sub-fence

001766

This tool is equipped with the sub-fence. It should be

positioned as shown in the figure.

CAUTION:

•

When performing left bevel cuts, flip the fence over

to the left position as shown in the figure. Otherwise,

it will contact the blade or a part of the tool, causing

possible serious injury to the operator.

001767

1. Vertical vise

012655

The vertical vise can be installed in two positions on

either the left or right side of the guide fence or the holder

assembly (optional accessory). Insert the vise rod into

the hole in the guide fence or the holder assembly and

tighten the screw to secure the vise rod.

Position the vise arm according to the thickness and

shape of the workpiece and secure the vise arm by

tightening the screw. If the screw to secure the vise arm

contacts the guide fence, install the screw on the

opposite side of vise arm. Make sure that no part of the

tool contacts the vise when lowering the handle all the

way. If some part contacts the vise, re-position the vise.

Press the workpiece flat against the guide fence and the

turn base. Position the workpiece at the desired cutting

position and secure it firmly by tightening the vise knob.

CAUTION:

• The workpiece must be secured firmly against the

turn base and guide fence with the vise during all

operations.

2. Horizontal vise (optional accessory)

001807

The horizontal vise can be installed on either the left or

right side of the base. When performing 15° or greater

miter cuts, install the horizontal vise on the side opposite

the direction in which the turn table is to be turned. By

turning the vise knob counterclockwise, the screw is

released and the vise shaft can be moved rapidly in and

out. By turning the vise knob clockwise, the screw

remains secured. To grip the workpiece, turn the vise

knob gently clockwise until the projection reaches its

topmost position, then fasten securely. If the vise knob is

forced in or pulled out while being turned clockwise, the

projection may stop at an angle. In this case, turn the vise

knob back counterclockwise until the screw is released,

before turning again gently clockwise.

The maximum width of the workpiece which can be

secured by the horizontal vise is 130 mm.

CAUTION:

• Grip the workpiece only when the projection is at

the topmost position. Failure to do so may result in

insufficient securing of the workpiece. This could

cause the workpiece to be thrown, cause damage

to the blade or cause the loss of control, which can

result in PERSONAL INJURY.

1. Vise knob

2. Projection

3. Vise shaft

4. Base

1. Vise rod

2. Screw

3. Vise knob

4. Vise arm

5. Guide fence

6. Holder assembly

7. Holder

1. Sub-fence

1. Support

2. Turn base

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

Makita LS1040F Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1040F