Makita PV7001C User Manual download pdf (Page 11)

Polishing operation by wool bonnet

CAUTION:

• Always wear safety glasses or a face shield during

operation.

Hold the tool firmly. Turn the tool on and then apply the wool

bonnet to the workpiece.

In general, keep the wool bonnet at an angle of about 15

degrees to the workpiece surface.

Apply slight pressure only. Excessive pressure will result in

poor performance and premature wear to wool bonnet.

Sanding operation

CAUTION:

• Always wear safety goggles or a face shield during

operation.

• Never switch on the tool when it is in contact with the

workpiece, it may cause an injury to operator.

• Never run the tool without the abrasive disc. You may

seriously damage the pad.

Hold the tool firmly. Turn the tool on and then apply the abra-

sive disc to the workpiece.

In general, keep the abrasive disc at an angle of about 15

degrees to the workpiece surface.

Apply slight pressure only. Excessive pressure will result in

poor performance and premature wear to abrasive disc.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

003480

003421

1. Limit mark

001145

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Makita PV7001C User Manual Page 11