Makita 2703X1 User Manual download pdf (Page 23)

How to perform rabbeting

1. Remove blade guard.

2. Attach auxiliary fence to rip fence for cuts that run the

length of the stock. Facing should be as high as the

workpiece is wide. Adjust fence and blade to desired

dimensions.

3. First cut: Hold board flat on table as in ordinary rip-

ping.

4. Second cut: Set workpiece on its edge. (Use feather-

boards, push stick, push block and so on, using pre-

cautions, safety rules and guidelines for ripping or

related work.)

5. For end-type rabbeting, if the workpiece is less than

10-1/2” wide, rest the wood flat on the table against

the miter gauge (with wood facing). The rip fence

should not be used.

6. After rabbeting is completed, immediately re-install

the blade guard as before.

Table saw stand (Part No. 192680-7)

Place the stays on a level location and assemble the

legs inside. Secure with the bolts and nuts, then attach

the rubber caps to the ends of the legs.

Now set the table saw on top of the assembled stand

and secure with four bolts, washers and nuts.

NOTE:

• Models 2702X1 and 2703X1 are standard-equipped

with a table saw stand.

1. Rabbet

2. First cut

3. Second cut

1. Bolt

2. Stand

1. Rubber cap

2. Nut

3. Leg

4. Under stay

5. Stay

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

No comments

Makita 2703X1 User Manual Page 23