Makita 4340CT User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.ENGLISHJig SawMODEL

10Dust extractionThe dust nozzle (accessory) is recommended to perform clean cutting opera-tions.To attach the dust nozzle on the tool, insert the ho

111. Straight cutsWhen repeatedly cutting widths of 160 mm or less, use of the rip fence willassure fast, clean, straight cuts. To install, insert the

12Guide rail adapter set (accessory)When cutting parallel and uniform width or cutting straight, the use of the guiderail and the guide rail adapter w

13Anti-splintering deviceFor splinter-free cuts, the anti-splintering device can be used. To install theanti-splintering device, move the tool base al

Memo14

Memo15

Makita Corporation Anjo, Aichi, Japan884426E228

2SPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to changewithout notice. • Note: S

3GENERAL SAFETY RULES GEA001-3WARNING:Read all instructions. Failure to follow all instructions listed below may result inelectric shock, fire and/or

419. Store idle power tools out of the reach of chil-dren and do not allow persons unfamiliar withthe power tool or these instructions to operatethe p

5FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and unplugged beforeadjusting or checking function on the tool.Selecting

6CAUTION:• The speed adjusting dial can be turned only as far as 5 and back to 1. Donot force it past 5 or 1, or the speed adjusting function may no l

7Keeping that situation, insert the saw blade into the blade clamp as far as thetwo protrusions of the blade can not be seen.Return the tool opener to

8Bevel cuttingCAUTION:• Always be sure that the tool is switched off and unplugged before tiltingthe tool base.With the tool base tilted, you can make

9CutoutsCutouts can be made with either of two methods A or B.A) Boring a starting holeFor internal cutouts without a lead-in cut from an edge, pre-dr