Makita 4323 User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comJ

10Tilt the base until the desired bevel angle is obtained. Theedge of the motor housing indicates the bevel angle by grad-uations. Then tighten the bo

11(4) Complete the cut in the normal manner.Finishing edgesTo trim edges or make dimensional adjustments, run theblade lightly along the cut edges.Met

12To install, insert the rip fence into the rectangular hole onthe side of the base with the fence guide facing down.Slide the rip fence to the desire

13ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo14

Memo15

Memo16

17First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

181. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

19FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

35.Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your b

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

58.Make sure the blade is not contacting theworkpiece before the switch is turned on.9.Keep hands away from moving parts.10.Do not leave the tool runn

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7CAUTION:• If the tool is operated continuously at low speeds for along time, the motor will get overloaded and heated up.• The speed adjusting dial c

8Hex wrench storageWhen not in use, store the hex wrench as shown in the figureto keep it from being lost.Adjusting rollerLoosen the bolt on the back

9OPERATIONCAUTION:• Always hold the base flush with the workpiece. Failure todo so may cause blade breakage, resulting in a seriousinjury.• Advance th