Makita DVC350 Instruction Manual download pdf (Page 7)

Operation of the cleaner with a nozzle or a

dust bag being installed

WARNING:

• Always be sure that the cleaner is switched off

and the battery cartridge is removed before

installing or removing the nozzle or any other

attachment on the cleaner. Failure to switch off

and remove the battery cartridge may result in

serious personal injury.

NOTE:

• Before the blower mode operation immediately

after the cleaner mode operation, remove all

remaining dust from the cleaner due to possible

blow out of dust .

Using as a blower

011124

Install the nozzle onto the outlet (air vent) without fail.

To install the nozzle, fit the pin protruding from the inside

of nozzle to one of the cleaner notches and then turn

the nozzle clockwise securely.

To remove the nozzle, turn counterclockwise and pull it

out.

Direct the top point of the cleaner and then switch on.

Emptying the dust bag

WARNING:

• Always be sure that both the cleaner and a

connected power tool are switched off and the

battery cartridge is removed and the power

tool, if corded tool, is unplugged before

installing or removing the dust bag on the

cleaner and emptying the dust bag( made of

cloth). Failure to switch off, remove the battery

cartridge and unplug the connected power tool

may result in electric shock and serious personal

injury.

• When the dust bag is about half full, remove the

dust bag from the cleaner and pull the fastener out.

Empty the dust bag of its contents, tapping it lightly

so as to remove particles adhering to the insides

which might hamper further collection.

NOTE:

• For the time to empty the dust bag, use a guide

line that the dust bag becomes full when

drilling about 450 holes with 6.5 mm diameter

and 40 mm depth on the concrete. A dust bag

clogged with the built up particles may reduce the

dust collection power and cause damage to the

cleaner motor.

CAUTION:

• Attach the dust bag (made of cloth) to the dust

bag joint securely and close the fastener

completely before use. Failure to attach the dust

bag securely and close its fastener completely may

cause blow-out of dust and result in serious

personal injury.

011125

Pick up the square section of the dust bag joint firmly,

turn it counterclockwise and then remove the dust bag.

011126

Open the fastener and dispose of the dust.

CAUTION:

• Remove all particles adhering to the fastener area.

1. Dust bag joint

2. Square section

1. Outlet (air vent)

2. Nozzle

3. Pin

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

Makita DVC350 Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Vacuum cleaners Makita DVC350