Makita BTL063 User Manual download pdf (Page 6)

Hook (Accessory)

CAUTION:

• When installing the hook, tighten the screw firmly.

Failure to do so may cause the breakage of the

tool or personal injury.

008338

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool.

To install the hook, insert it into a groove in the tool

housing on either side and then secure it with a screw.

To remove, loosen the screw and then take it out.

Adjusting the angle head

The angle head can be adjusted 360°(8 positions in

45-degree increments). To adjust it, loosen the hex bolt

and remove the angle head.

Adjust the angle head to the desired position and

reinstall it so that the teeth on the housing will match up

with the grooves in the angle head. Then tighten the hex

bolt to secure the angle head.

008335

008336

Straight head and ratchet head (Accessory)

Straight heads and ratchet heads are available as

optional accessories for various applications on the job.

002828

002829

OPERATION

CAUTION:

• Always insert the battery cartridge all the way until

it locks in place. If you can see the red part on the

upper side of the button, it is not locked completely.

Insert it fully until the red part cannot be seen. If not,

it may accidentally fall out of the tool, causing injury

to you or someone around you.

Hold the tool firmly and place the socket over the bolt or

nut. Turn the tool on and fasten for the proper fastening

time.

008497

The proper fastening torque may differ depending upon

the kind or size of the bolt, the material of the workpiece

to be fastened, etc. The relation between fastening

torque and fastening time is shown in the figures.

1. Ratchet head

1. Straight head

1. Groove

2. Tooth

1. Hex bolt

2. Angle head

1. Groove

2. Screw

3. Hook

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Makita BTL063 User Manual Page 6

Comments to this Manuals

Related products and manuals for Tools Makita BTL063