Makita HR2610 Instruction Manual download pdf (Page 5)

Reversing switch action

010722

CAUTION:

• Always check the direction of rotation before

operation.

• Use the reversing switch only after the tool comes

to a complete stop. Changing the direction of

rotation before the tool stops may damage the tool.

• If the switch trigger can not be depressed, check to

see that the reversing switch is fully set to

position

(A side) or (B side).

This tool has a reversing switch to change the direction of

rotation. Move the reversing switch lever to the

position

(A side) for clockwise rotation or the

position (B side)

for counterclockwise rotation.

Changing the quick change chuck for

SDS-plus

For Models HR2310T, HR2610T, HR2611FT

The quick change chuck for SDS-plus can be easily

exchanged for the quick change drill chuck.

Removing the quick change chuck for SDS-plus

011561

CAUTION:

• Before removing the quick change chuck for

SDS-plus, always remove the bit.

Grasp the change cover of the quick change chuck for

SDS-plus and turn in the direction of the arrow until the

change cover line moves from the

symbol to the

symbol. Pull forcefully in the direction of the arrow.

Attaching the quick change drill chuck

011562

Check the line of the quick change drill chuck shows the

symbol. Grasp the change cover of the quick change

drill chuck and set the line to the

symbol.

Place the quick change drill chuck on the spindle of the

tool.

Grasp the change cover of the quick change drill chuck

and turn the change cover line to the

symbol until a

click can clearly be heard.

Selecting the action mode

For Models HR2300, HR2600, HR2601

010723

This tool employs an action mode changing knob. Select

one of the two modes suitable for your work needs by

using this knob.

For rotation only, turn the knob so that the arrow on the

knob points toward the

symbol on the tool body.

For rotation with hammering, turn the knob so that the

arrow on the knob points toward the

symbol on the tool

body.

CAUTION:

• Always set the knob fully to your desired mode

symbol. If you operate the tool with the knob

positioned halfway between the mode symbols, the

tool may be damaged.

• Use the knob after the tool comes to a complete

stop.

1. Rotation with

hammering

2. Rotation only

3. Action mode

changing knob

1. Spindle

2. Quick change

drill chuck

3. Change cover

line

4. Change cover

1. Quick change

chuck for

SDS-plus

2. Change cover

line

3. Change cover

1. Reversing switch

lever

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR2610 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR2610