Makita HR2610 Instruction Manual download pdf (Page 8)

010718

Adjust the depth gauge to the desired depth by moving it

back and forth while pressing the lock button. After the

adjustment, release the lock button to lock the depth

gauge.

010719

NOTE:

• Inserting the depth gauge with its toothed side not

directed to the toothed side of hex hole marking on

the grip base as shown in the figure does not allow

the depth gauge to be locked.

Dust cup

010731

Use the dust cup to prevent dust from falling over the tool

and on yourself when performing overhead drilling

operations. Attach the dust cup to the bit as shown in the

figure. The size of bits which the dust cup can be

attached to is as follows.

Bit diameter

Dust cup 5 6 mm - 14.5 mm

Dust cup 9

12 mm - 16 mm

006406

There is another type of dust cup (accessory) which

helps you prevent dust from falling over the tool and on

yourself when performing overhead drilling operations.

Installing or removing the dust cup

011506

Before installing the dust cup, remove the bit from the

tool if installed on the tool. Install the dust cup

(accessory) on the tool so that the

symbol on the

dust cup is aligned with the grooves in the tool.

010733

To remove the dust cup, pull the chuck cover in the

direction as shown in the figure and with the chuck cover

pulled take the bit out of the tool.

010734

And then grab the attachment at the foot of dust cup and

take it out.

011507

1. Bellows

2. Attachment

1. Attachment at

the foot of dust

cup

1. Bit

2. Chuck cover

symbol

2. Grooves

3. Dust cup

1. Dust cup

1. Toothed side of

hex hole

marking on the

grip base

2. Toothed side of

the depth gauge

1. Lock button

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR2610 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR2610