Makita HR2610 Instruction Manual download pdf (Page 10)

After drilling the hole, use the blow-out bulb to clean the

dust out of the hole.

Chipping/Scaling/Demolition

For Models HR2310T, HR2610, HR2610T, HR2611F,

HR2611FT

011564

Set the action mode changing knob to the symbol.

Hold the tool firmly with both hands. Turn the tool on and

apply slight pressure on the tool so that the tool will not

bounce around, uncontrolled. Pressing very hard on the

tool will not increase the efficiency.

Drilling in wood or metal

For Models HR2300, HR2600, HR2601, HR2610,

HR2611F

011560

Use the optional drill chuck assembly. When installing it,

refer to "Installing or removing the bit" described on the

previous page.

For Models HR2310T, HR2610T, HR2611FT

011561

011562

Use the quick change drill chuck as standard equipment.

When installing it, refer to "changing the quick change

chuck for SDS-plus " described on the previous page.

011563

Hold the ring and turn the sleeve counterclockwise to

open the chuck jaws. Place the bit in the chuck as far as it

will go. Hold the ring firmly and turn the sleeve clockwise

to tighten the chuck. To remove the bit, hold the ring and

turn the sleeve counterclockwise.

Set the action mode changing knob to the

symbol.

You can drill up to 13 mm diameter in metal and up to 32

mm diameter in wood.

CAUTION:

• Never use "rotation with hammering" when the

quick change drill chuck is installed on the tool. The

quick change drill chuck may be damaged.

Also, the drill chuck will come off when reversing

the tool.

• Pressing excessively on the tool will not speed up

the drilling. In fact, this excessive pressure will only

serve to damage the tip of your bit, decrease the

tool performance and shorten the service life of the

tool.

• There is a tremendous twisting force exerted on the

tool/bit at the time of hole breakthrough. Hold the

tool firmly and exert care when the bit begins to

break through the workpiece.

• A stuck bit can be removed simply by setting the

reversing switch to reverse rotation in order to back

out. However, the tool may back out abruptly if you

do not hold it firmly.

• Always secure small workpieces in a vise or similar

hold-down device.

1. Sleeve

2. Ring

3. Quick change

drill chuck

1. Spindle

2. Quick change

drill chuck

3. Change cover

line

4. Change cover

1. Quick change

chuck for

SDS-plus

2. Change cover

line

3. Change cover

1. Chuck adapter

2. Keyless drill

chuck

1 ... 9 10 11 12

Comments to this Manuals

No comments

Makita HR2610 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR2610