Makita HR2000 Instruction Manual download pdf (Page 7)

Hammer drilling operation

*Position the bit

the location for

the

hole, then pull the trigger.

not force the tool. Light pressure

gives

best results. Keep the tool in posi-

tion and prevent it from slipping away

from the hole.

*Do

not apply more pressure when the

hole becomes clogged with chips or par-

ticles. Instead, run the tool

an idle,

then remove from the hole.

repeating

this several times, the hole will be cleaned

out.

Dust cup

Use the dust cup to prevent dust from fall-

ing over the

tool

and on yourself when

performing overhead drilling operations.

Attach the dust cup to the bit

shown in

the figure. The dust cup can be attached to

the bit up to 14.5 mm (9/16') in diameter.

Drilling in

wood

or metal

Use the optional drill chuck assembly (con-

sisting

drill chuck, chuck adapter and

screw) for drilling up to 13 mm

(1/2")

metal and up to 18 mm (1 1/16") in wood.

install

it,

refer to "installing or remov-

ing drill bit".

-I---

-Bit

CUP

Drill

chuck

CAUTION

Be sure to use only the drill chuck assembly or chuck adapter assembly specified in this

man ua

(See "accessories"

The use of any other drill chuck assembly

chuck adapter assembly may cause damage

to the drill chuck or chuck adapter. Also, the screw holding the drill chuck and chuck

adapter together will come loose when reversing the tool.

NOTE

If you need assemble the drill chuck and chuck adapter assembly, proceed

follows.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR2000 Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Power tools Makita HR2000