Makita AF502 Instruction Manual

Pneumatic Brad Nailer Air pressure kgficm2G (60 - 100 PSIG) MODEL AF502 Dimensions Net weight (L x W x H) Applicable length (Brad nails) Nail capaci

TOOL INSTALLATION INSTRUCTIONS AND USE Selecting compressor The air compressor must comply with the requirements of Select a compressor that has ampl

Nose adapter CAUTIO N : Always lock the trigger and disconnect the hose before installing or removing the nose adapter. To prevent the workpiece from

Adjusting depth of nailing CAUTIO N : Always lock the trigger and disconnect the hose before adjusting the depth of nailing. Adjust the depth of nail

3. Depress the contact arm against the workpiece. 4. Pull the trigger to drive a nail. To drive another nail, release the trigger and lift the tool

Jammed nailer CAUTION: Always lock the trigger, disconnect the hose and remove the nails from the magazine before cleaning a jam. When the nailer beco

Nails Handle nail strips and their box carefully. If the nail strips Avoid storing nails in a very humid or hot place or place exposed to direct sunl

MAINTENANCE CAUTION: Always be sure that the trigger is locked and the air hose is disconnected from the tool before attempting to perform inspection

Maintenance of compressor, air set and air hose After operation, always drain the compressor tank and the air filter. If moisture is allowed to enter

MEMO

IMPORTANT SAFETY INSTRUCTIONS WARNING: WHEN USING THIS TOOL, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF PERSONA

MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to

General Tool Handling Guidelines: 1. Always assume that the tool contains fasteners. 2. Do not point the tool toward yourself or anyone whether it con

*Only those involved in the work should be in the vicinity. Children especially must be kept away at all times. There may be local regulations concern

Never use the tool with other than compressed air. If bottled gas (carbon dioxide, oxgen, nitrogen, hydrogen, air, etc.) or combustible gas (hydr

Use only nails specified in this manual. The use of any other nails may cause malfunction of the tool. I Do not permit those uninstructed to use the t

*On rooftops and other high locations, nail as you move forward. It is easy to lose your footing if you nail while inching backward. When nailing agai

When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. Accidental firing can b

Perform cleaning and maintenance right after finish- ing the job. Keep the tool in tip-top condition. Lubricate moving parts to prevent rustin