Makita BGA452 Instruction Manual download pdf (Page 9)

Switch action

007217

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the slide switch actuates

properly and returns to the "OFF" position when the

rear of the slide switch is depressed.

To start the tool, slide the slide switch toward the "I (ON)"

position. For continuous operation, press the front of the

slide switch to lock it.

To stop the tool, press the rear of the slide switch, then

slide it toward the "O (OFF)" position.

Indication lamp with multi function

007224

Indication lamps are located in two positions.

When the battery cartridge is inserted on the tool with the

slide switch positioned in the "O (OFF)" position, the

indication lamp flickers quickly for approximately one

second. If it does not flicker so, the battery cartridge or

indication lamp has broken.

− Overload protection

− When the tool is overloaded, the indication

lamp lights up. When the load on the tool is

reduced, the lamp goes out.

− If the tool continues to be overloaded and the

indication lamp continues to light up for

approximately two seconds, the tool stops.

This prevents the motor and its related parts

from being damaged.

− In this case, to start the tool again, move the

slide switch to the "O (OFF)" position once

and then to the "I (ON)" position.

− Battery cartridge replacing signal

− When the remaining battery capacity gets

small, the indicator lamp lights up during

operation earlier than enough capacity battery

use.

− Accidental re-start preventive function

− Even if the battery cartridge is inserted on the

tool with the slide switch in the "I (ON)"

position, the tool does not start. At this time,

the lamp flickers slowly and this shows that

the accidental re-start preventive function is at

work.

− To start the tool, first slide the slide switch

toward the "O (OFF)" position and then slide it

toward the "I (ON)" position.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out

any work on the tool.

Installing side grip (handle)

007225

CAUTION:

• Always be sure that the side grip is installed

securely before operation.

Screw the side grip securely on the position of the tool as

shown in the figure.

Installing or removing wheel guard (For

depressed center wheel , multi disc / abrasive

cut-off wheel , diamond wheel)

For tool with locking screw type wheel guard

007218

WARNING:

• When using a depressed center grinding

wheel/Multi-disc, flex wheel, wire wheel brush,

cut-off wheel or diamond wheel, the wheel guard

must be fitted on the tool so that the closed side of

1. Wheel guard

2. Bearing box

3. Screw

1. Indication lamp

1. Slide switch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Makita BGA452 Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Makita BGA452