1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE TH
10 12 009863 Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of t
11 009877 How to use screw M6 x 135 for adjusting the depth of cut When using the tool with a router table available in the market, using this scre
12 MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replac
13 "U"Grooving bit R 005117 mmDAL 1L 2R6 6 50 18 3 006453 "V"Grooving bit 005118 mmDAL 1L 21/4" 20 50 15 90 006454
14 Chamfering bit 005126 mmD A L 1 L 2 L 3666204914220 50 13 523 46 11 6 30 45 60 006462 Cove beading bit 005129 mmDAL 1L 2R20 43 8 466254813
15 Ball bearing cove beading bit 005134 mmD A 1 A 2 A 4 L 1 L 2 L 3 R665.5 351012 526 22 8 4220 18 8A 31212 40 006469 Ball bearing roman ogee bit
16 Makita Corporation Anjo, Aichi, Japan 884877B225
2 ENGLISH SPECIFICATIONS Model RP1800 / RP1800F RP1801 / RP1801F RP2300FC RP2301FC Collet chuck capacity 12 mm or 1/2" Plunge capacity 0 - 70 m
3 For Model RP1800,RP1800F,RP1801 ENG102-3 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA) : 86 d
4 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of
5 5. Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately. 6. Avoid cutting nails. Inspect for
6 Stopper block 123 009858 The stopper block has three adjusting hex bolts which raise or lower 0.8 mm per turn. You can easily obtain three differe
7 Numbermin-1123459,00011,00014,00017,00020,0006 22,000 009875 CAUTION: • If the tool is operated continuously at low speeds for a long time, the m
8 Always use both grips and firmly hold the tool by both grips during operations. Set the tool base on the workpiece to be cut without the bit making
9 the side of the workpiece is not straight, the straight guide cannot be used. In this case, firmly clamp a straight board to the workpiece and use i
Comments to this Manuals