4
ENGLISH (Original instructions)
Explanation of general view
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Lamp
4-1. Reversing switch lever
5-1. Speed change lever
6-1. Action mode change lever
7-1. Adjusting ring
7-2. Graduations
7-3. Arrow
8-1. Steel band
8-2. Grip base
8-3. Side grip
8-4. Protrusion
8-5. Groove
9-1. Sleeve
10-1. Bit holder
10-2. Bit
11-1. Screw
11-2. Hook
11-3. Groove
13-1. Limit mark
14-1. Rear cover
14-2. Screws
15-1. Arm
15-2. Spring
15-3. Recessed part
16-1. Carbon brush cap
17-1. Hole
17-2. Carbon brush cap
SPECIFICATIONS
Model BDF441 BDF451
Steel 13 mm 13 mm
Wood 50 mm 65 mm
Wood screw 6 mm x 75 mm 10 mm x 89 mm
Capacities
Machine screw 6 mm
High (3) 0 - 1,700
Medium (2) 0 - 600
No load speed (min
-1
)
Low (1) 0 - 300
Overall length 238 mm
Net weight 2.3 kg 2.4 kg
Rated voltage D.C. 14.4 V D.C. 18 V
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
ENE034-1
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
For Model BDF441
ENG103-4
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 70 dB(A) or less
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB(A)
Wear ear protection
ENG202-3
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
For Model BDF451
ENG104-2
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 72 dB(A)
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
ENG202-3
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Comments to this Manuals