Battery-Powered Driver Drill Steel / Wood 10 mm (318") Equipped with Electric Brake 10 mm (3/8") MODEL 601D 10 mm (3/8") MODEL 6OlDST W
Connecting the battery to the tool Connect the battery to the tool using the adaptor cord. To prevent the adaptor cord from being accidentally disconn
Screwdriving operation Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase
MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery is disconnected from the tool before attempting to perform inspecti
Dec -19-’94 US 10 mm (3/8”) Model 601D BATTERY-POWERED DRIVER DRILL Note: The switch and other part configurations may differ from country to coun
1 1 Name Plate 10 2 5 Tapping Screw 4x20 11 12 3 1 Housing Set IWith Item 181 14 5 1 Lever 15 6 1 Trigger 7 1 Inlet 16 8 1 Motor I0.C. 12 V
Recycling the battery The only way to dispose of a Makita battery is to recycle it. The law prohibits any other method of disposal. To recycle the
IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE R
14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY & CHARGER Length of Cord (Feet) 25 AWG Size of Cord 18 I. SAVE THESE INSTRUCTIONS - This manual 50 1
ADDITIONAL SAFETY RULES FOR BATTERY 1. Always charge the Makita battery 122 immediately after purchase. 2. Always recharge the Makita battery 122 a
ADDITIONAL SAFETY RULES FOR CHARGER 1. The Makita charger Model DC122 is specifically designed to charge only the Makita battery 121 or 122. Do not
ADDITIONAL SAFETY RULES FOR TOOL 1. This tool is specifically designed to drill in woods/metals or to drive wood 2. Always be sure you have a firm
Charging Connect the battery to the charger using the adaptor cord. Then plug the charger into the power source. The charging light will illuminate a
Installing or removing the drill bit CAUTION : Always be sure that the tool is switched off and the batterv is disconnected from the tool before insta
Comments to this Manuals