Makita LS1013L Instruction Manual download pdf (Page 9)

NOTE:

• Use a dry cloth to wipe the dirt off the lens of lamp.

Be careful not to scratch the lens of light, or it may

lower the illumination.

Laser beam action

For model LS1013L,LS1013FL only

006339

CAUTION:

• Never look into the laser beam. Direct laser beam

may injure your eyes.

• LASER RADIATION, DO NOT STARE INTO THE

BEAM OR VIEW DIRECTLY WITH OPTICAL

INSTRUMENTS, CLASS 2M LASER PRODUCT.

To turn on the laser beam, press the upper position (I) of

the switch. Press the lower position (O) to turn off.

Laser line can be shifted to either the left or right side of

the saw blade by adjusting the adjusting screw as

follows.

006340

1. Loosen the adjusting screw by turning it

counterclockwise.

2. With the adjusting screw loosened, slide the

adjusting screw to the right or left as far as it goes.

3. Tighten the adjusting screw firmly at the position

where it stops sliding.

Laser line is factory adjusted so that it is positioned

within 1 mm from the side surface of the blade (cutting

position).

NOTE:

• When laser line is dim and almost or entirely

invisible because of the direct sunlight in the indoor

or outdoor window-by work, relocate the work area

to a place not exposed to the direct sunlight.

Aligning the laser line

006341

Laser line can be shifted to either the left or right side of

the blade according to the applications of cutting. Refer

to explanation titled "Laser beam action" regarding its

shifting method.

NOTE:

• Use wood facing against the guide fence when

aligning the cutting line with the laser line at the

side of guide fence in compound cutting (bevel

angle 45 degrees and miter angle right 45

degrees).

A) When you obtain correct size on the left side of

workpiece

• Shift the laser line to the left of the blade.

B) When you obtain correct size on the right side of

workpiece

• Shift the laser line to the right of the blade.

Align the cutting line on your workpiece with the laser

line.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Socket wrench storage

001530

The socket wrench is stored as shown in the figure.

When using the socket wrench, pull it out of the wrench

holder. After using the socket wrench, return it to the

wrench holder.

1. Socket wrench

2. Wrench holder

1. Adjusting screw

1. Switch for laser

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Makita LS1013L Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1013L