Makita LS1013L Instruction Manual download pdf (Page 12)

001549

Sub-fence

001545

This tool is equipped with the sub-fence which should

ordinarily be positioned as shown in the figure.

However, when performing left bevel cuts, set it to the

left position as shown in the figure.

CAUTION:

• When performing left bevel cuts, flip the fence over

to the left position as shown in the figure.

Otherwise, it will contact the blade or a part of the

tool, causing possible serious injury to the

operator.

001546

Sub-fence R (optional accessory)

001547

The sub-fence R can be installed on the right side of the

guide fence. Insert the rods of the sub-fence R into the

holes in the guide fence. Tighten the screws which come

with the sub-fence R to secure the sub-fence R.

CAUTION:

•

When performing right bevel cuts, never use the

sub-fence R. It will contact the blade or a part of the

tool, causing possible serious injury to the operator.

Vertical vise

001548

The vertical vise can be installed in two positions on

either the left or right side of the guide fence or the base.

Insert the vise rod into the hole in the guide fence or the

base and tighten the screw on the back of the guide

fence to secure the vise rod.

Position the vise arm according to the thickness and

shape of the workpiece and secure the vise arm by

tightening the screw. If the screw to secure the vise arm

contacts the guide fence, install the screw on the

opposite side of vise arm. Make sure that no part of the

tool contacts the vise when lowering the handle fully and

pulling or pushing the carriage all the way. If some part

contacts the vise, re-position the vise.

Press the workpiece flat against the guide fence and the

turn base. Position the workpiece at the desired cutting

position and secure it firmly by tightening the vise knob.

CAUTION:

• The workpiece must be secured firmly against the

turn base and guide fence with the vise during all

operations.

Horizontal vise (optional accessory)

2 3

001550

1. Vise plate

2. Vise nut

3. Vise knob

1. Vise arm

2. Vise rod

3. Screw

4. Vise knob

5. Guide fence

1. Sub-fence R

2. Screws

1. Sub-fence

1. Support

2. Turn base

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Makita LS1013L Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Mitre saws Makita LS1013L