Makita BHR200SJE Instruction Manual download pdf (Page 8)

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before carrying out

any work on the tool.

Side grip

The side grip swings around to either side, allowing easy

handling of the tool in any position. Loosen the side grip

by turning it counterclockwise, swing it to the desired

position and then tighten it by turning clockwise.

Bit grease (optional accessory)

Coat the bit shank head beforehand with a small amount

of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck

lubrication assures smooth action and longer service life.

Installing or removing the bit

Clean the bit shank and apply bit grease before installing

the bit.

Insert the bit into the tool. Turn the bit and push it in until

it engages.

If the bit cannot be pushed in, remove the bit. Pull the

chuck cover down a couple of times. Then insert the bit

again. Turn the bit and push it in until it engages.

After installing, always make sure that the bit is securely

held in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way

and pull the bit out.

Bit angle

(when chipping, scaling or demolishing)

To change the bit angle, depress the lock button and

rotate the change lever so that the pointer points to the

“O” symbol. Turn the bit to the desired angle.

Depress the lock button and rotate the change lever so

that the pointer points to the symbol. Then make sure

that the bit is securely held in place by turning it slightly.

1. Side grip

1. Bit shank

2. Bit grease

1. Bit

2. Chuck cover

003141

003150

003157

1. Change lever

2. O symbol

1. Change lever

003166

003170

003174

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Makita BHR200SJE Instruction Manual Page 8

Comments to this Manuals