Makita LS1030N Specifications download pdf (Page 19)

Lower the handle fully and lock it in the lowered position

by pushing in the stopper pin. Square the side of the

blade with the face of the guide fence using a triangular

rule, try-square, etc. Then securely tighten the hex bolts

on the guide fence in the order from the right side.

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

After replacing brushes, plug in the tool and break in brushes

by running tool with no load for about 10 minutes. Then

check the tool while running and electric brake operation

when releasing the switch trigger. If electric brake is not

working well, ask your local Makita service center for repair.

After use

• After use, wipe off chips and dust adhering to the tool

with a cloth or the like. Keep the blade guard clean

according to the directions in the previously covered

section titled “Blade guard”. Lubricate the sliding

portions with machine oil to prevent rust.

To maintain product SAFETY and RELIABILITY, repairs, any

other maintenance or adjustment should be performed by

Makita Authorized or Factory Service Centers, always using

Makita replacement parts.

1. Triangular rule

2. Grip

3. Guide fence

001780

1. Limit mark

001145

1. Screwdriver

2. Brush holder cap

001772

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Makita LS1030N Specifications Page 19