Makita GA7001L Specifications download pdf (Page 11)

Operation with wire wheel brush

(optional accessory)

CAUTION:

• Check operation of wire wheel brush by running tool with

no load, insuring that no one is in front of or in line with

the wire wheel brush.

• Do not use wire wheel brush that is damaged, or which

is out of balance. Use of damaged wire wheel brush

could increase potential for injury from contact with

broken wires.

• ALWAYS use guard with wire wheel brushes, assuring

diameter of wheel fits inside guard. Wheel can shatter

during use and guard helps to reduce chances of

personal injury.

Unplug tool and place it upside down allowing easy access

to spindle. Remove any accessories on spindle. Thread wire

wheel brush onto spindle and tighten with the wrenches.

When using wire wheel brush, avoid applying too much pres-

sure which causes over bending of wires, leading to prema-

ture breakage.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection or

maintenance.

The tool and its air vents have to be kept clean. Regularly

clean the tool’s air vents or whenever the vents start to

become obstructed.

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

1. Wire wheel brush

001236

1. Exhaust vent

2. Inhalation vent

001169

1. Limit mark

001145

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Makita GA7001L Specifications Page 11