Makita HM0860C User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comD

10LubricationThis tool requires no hourly or daily lubrication because ithas a grease-packed lubrication system. It should be relubri-cated after ever

11Connect the terminal and reinstall the handle.CAUTION:• Be careful not to damage the terminal or lead wiresespecially when wiping out the old grease

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

36. Do not expose power tools to rain or wetconditions. Water entering a power tool willincrease the risk of electric shock.7. Do not abuse the cord.

424. When servicing a tool, use only identicalreplacement parts. Follow instructions inthe Maintenance section of this manual.Use of unauthorized part

5tion. Without proper warm-up, hammeringoperation is difficult.7. Always be sure you have a firm footing.Be sure no one is below when using thetool in

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Indicator lampThe green power-ON indicator lamp lights up when the tool isplugged. The indicator lamp is lit but the tool does not starteven if the t

8Insert the bit into the tool. Turn the bit and push it in until itengages.If the bit cannot be pushed in, remove the bit. Pull the chuckcover down a

9MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspection ormaintenance.Replacing carbon