Makita 4304T Instruction Manual download pdf (Page 9)

Flush cutting

Loosen

the

base securing

lever

and slide the

base

all

the way back. Then tighten the

base securing lever to secure the base.

cutouts

Cutouts can be made with either

two methods A or

A) Boring

starting hole:

For internal cutouts without

lead-in

cut from and edge, pre-drill starting hole

more than 12 mm (1 5/32") in diameter.

Insert the blade into this hole and hold

the tool firmly against the workpiece

to start your cut.

Plung cutting:

You need not bore

starting hole

make

lead-in cut if you carefully

follows:

Tilt the tool up on the front edge of

the base, with the blade point posi-

tioned just above the workpiece sur-

face.

2. Apply firm pressure to the tool

that the front edge

the base will

not move when you switch on the

tool and gently lower the back end

of the tool slowly.

,-,/---

3. As the blade slices into the workpiece, slowly lower the base

the tool down onto

Complete the cut in the normal manner.

the workpiece surface.

1 2 3 4 5 6 7 8 9 10 ... 20

Comments to this Manuals

No comments

Makita 4304T Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools Makita 4304T