Makita 4304T Instruction Manual

Jig Saw Model 4304T 4305T . MODEL 4304T MODEL 4305T Variable Speed Variable Speed INSTRUCTION ~ MANUAL Length Max. cutting capacities Strokes Overall

Finishing edges To trim edges or make slight dimensional adjustments, run the blade lightly along the cut edges. // Metal cutting Always use a suitabl

Guide rule (rip fence; optional accessory) When cutting widths of under 150 mm (5-29/32") repeatedly, use of the guide rule will assure fa

MAINTENANCE CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Cleaning the

ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other acc

Jig saw blade Wood and plywood Plastics Aluminum 1.5 - 3 mm thick 1 - 6 mm thick - 11/16'' - 118") 13/64" - 1/4"l H Blade

JIG SAW Model 4304T Note: The switch, noise suppressor and other part configurations may differ from country to country. 15

ITEM NO. NO. USE0 DESCRIPTION $2D DESCRIPTION MACHINE - 1 2 3 4 5 6 7 8 9 10 11 12 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35

JIG SAW Model 4305T Note: The switch, noise suppressor and other part configurations may differ from country to country. 17

'iiM ,,!& DESCRIPTION MACHINE 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 76 77 78 79 80 82 82

19

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE R

MAKCTA LIMCTED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 1

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified

Installing or removing the saw blade CAUTION : .Always be sure that the tool is switched off and unplugged before installing or removing the blade.

For 4305T 1. Press the button to raise the blade installing knob. 2. Rotate the blade installing knob in the 0 direction and the clamp on the blade h

Switch action For 4304T CAUTION : Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "

Refer to the table at right to Select the Pro- However, the appropriate speed may differ Mild Steel per speed for the workpiece to be cut. wit

Flush cutting Loosen the base securing lever and slide the base all the way back. Then tighten the base securing lever to secure the base. cutout