Makita DCS 400DCS 401 Service Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
24
A
Working in winter
B
In order to prevent carburetor icing in conditions of low temper-
ature combined with high humidity, and in order to get up to
operating temperature faster in subfreezing temperatures,
heated air can be taken from the cylinder (marking (circled) on
insert in "snowflake" position).
At temperatures above freezing the carburetor must NOT be
fed heated air (marking (circled) on insert in "sun" position).
Failure to follow these instructions can lead to damage
to the cylinder and piston!
- Remove the filter cover (B/1).
- Position the universal wrench (B/2) as shown above and
push the insert (B/3) out by tapping the wrench.
- Put the insert (B/3) back in in the appropriate position, i.e. with
the marking next to the sun symbol for normal operation or
the snowflake symbol for subfreezing operation.
- Replace filter cover (B/1).
1
2
3
MAINTENANCE
Sharpening the saw chain
CAUTION:
Before doing any work on the guide bar or chain,
always
switch off the engine and pull the plug cap off the
spark plug (see "Replacing the spark plug"). Always wear
protective gloves!
D
Proper sharpening:
CAUTION:
Use only chains and guide bars designed for this saw (see
the Extract from the spare-parts list)!
- All cutters must be of the same length (dimension a).
Cutters with different lengths result in rough running of the
chain and can cause cracks in the chain.
- Minimum cutter length is 0.11" (3 mm). Do not resharpen
the chain when the minimum cutter length has been
reached; at this point, the chain must be replaced (see the
Extract from the spare-parts list and "Replacing the chain").
- The depth of the cut is determined by the difference in
height between the depth limiter (round nose) and the
cutting edge.
- The best results are obtained with a depth-limiter depth
of 0.65 mm (.025").
CAUTION:
Excessive depth increases the risk of kickback!
subfreezing operation
normal operation
C
The chain needs sharpening when:
- The sawdust produced when sawing damp wood looks
like wood flour.
- The chain penetrates the wood only under great pressure.
- The cutting edge is visibly damaged.
- The saw is pulled to the left or right when sawing. This is
caused by uneven sharpening of the chain.
Important: Sharpen frequently, but without removing
too much metal!
Generally, 2 or 3 strokes of the file will be enough.
Have the chain resharpened at a service center when you
have already sharpened it yourself several times.
0.65 mm
(.025")
0.65 mm
(.025")
min.
3 mm (0.11)
STOP
Page view 23
1 ... 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments