Makita DPC 6400 User Manual download pdf (Page 13)

11 12

NOTE: The two fastening nuts (11) must be loosened before

tightening the V-belt or checking the tension.

To increase the belt tension, turn the tightening screw (12) to

the right (clockwise) with the combination wrench included

with the Power Cut.

The belt tension is correctly adjusted when the nut (13) is

centred on the mark (14).

IMPORTANT:

After tightening/inspection, make certain to tighten

the fastening nuts (11) (30 ± 2 Nm).

Tightening the V-belt /

Checking V-belt tension

IMPORTANT

Exact V-belt tension is essential for maximum cutting

performance with minimum fuel consumption. Improper

V-belt tension will result in premature wear to the V-belt

and V-belt wheel or damage to the clutch bearing.

Fuels

Caution:

The Power Cut uses mineral-oil products (gasoline and

oil).

Be especially careful when handling gasoline.

Do not smoke. Do not allow gasoline to come near flames,

sparks or fire (explosion hazard).

Fuel mixture

The Power Cut is powered by a high-performance two-stroke

engine. It runs on a mixture of gasoline and two-stroke engine

oil.

The engine is designed for unleaded regular gasoline with a min.

octane value of 91 ROZ. In case no such fuel is available, you

can use fuel with a higher octane value. This will not affect the

engine.

In order to obtain an optimum engine output and to protect

your health and the environment use unleaded fuel only.

Gasoline which contens alcohol should not used in

MAKITA products.

To lubricate the engine, use a two-stroke engine oil (quality

grade TC-3), which is added to the fuel. The engine is designed

for the use of MAKITA HP 100 high-performance two-stroke

engine oil at a mixture ratio of only 100:1 to protect the environ-

ment. In addition, this ensures a long service life and reliable

operation with minimum exhaust emissions.

Gasoline

50:1

100:1

The correct mixture ratio:

100:1 When using MAKITA HP 100 high-performance

two-stroke engine oil, i. e. 100 parts gasoline to

1 part oil.

50:1 When using MAKITA high-performance two-

stroke engine oil, i. e. 50 parts gasoline to 1

part oil.

OIL

50:1

HP 100

1.0 Us-gal.

(3.7 l) 1.25 floz. (37 cm

) 2.6 floz. (75 cm

)

2.5 Us-gal.

(9.4 l) 3.2 floz. (94 cm

) 6.4 floz. (189 cm

)

5.0 Us-gal.

(18.9 l) 6.4 floz. (189 cm

) 12.8 floz. (378 cm

)

STOP

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Comments to this Manuals

No comments

Makita DPC 6400 User Manual Page 13

Comments to this Manuals

Related products and manuals for Petrol tool Makita DPC 6400