Makita RZ 100 Instruction Manual download pdf (Page 39)

100

101

Appendix

Makita LD100P

FIN

SLO

RUS

EST

ROK

Storage of constants/historical

storage

Storage of a constant

You can store and recall a frequently used value e.g.

height of a room. Measure the desired distance,

press and hold the button until the device beeps

to confirm storage.

Recalling the constant

Press this button once to recall the constant

and make it available for further calculations by

pressing button .

Historical storage

Press this button twice and the previous 20

results (measurements or calculated results) are

shown in reverse order.

The and buttons can be used for navigation.

Press this button to use a result from the

summary line for further calculations.

Pressing the and buttons at the same time

erases all the values in historical storage.

Timer (self-triggering)

Press this button to set a 5-second time delay.

Press and hold down this button until the

desired time delay is reached (max. 60 seconds).

Once the key is released the remaining seconds until

measurement (e.g. 59, 58, 57...) are displayed in a

countdown. The last 5 seconds are counted down

with a beep. After the last beep the measurement is

taken and the value is displayed.

)

The timer can be used for all measurements.

Appendix

Message codes

All message codes are displayed with either or

"Error". The following errors can be corrected:

Cause Remedy

156

Transverse tilt

greater than 10°

Hold the instrument

without any transverse

tilt

160

Main tilt direction,

angle too high

(> 45°)

Measure angle up to

max. ± 45°

204

Calculation error Repeat procedure

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 409 410

Comments to this Manuals

No comments

Makita RZ 100 Instruction Manual Page 39

Comments to this Manuals

Related products and manuals for Networking Makita RZ 100