Makita SLIDE COMPOUND SAW LS1011N Specifications download pdf (Page 9)

Maintaining maximum cutting capacity

This tool is factory adjusted to provide the maximum cutting

capacity for a 255 mm (10”) saw blade.

When installing a new blade, always check the lower limit

position of the blade and if necessary, adjust it as follows:

First, unplug the tool. Push the carriage toward the guide

fence fully and lower the handle completely. Use the socket

wrench to turn the adjusting bolt until the periphery of the

blade extends slightly below the top surface of the turn base

at the point where the front face of the guide fence meets the

top surface of the turn base.

With the tool unplugged, rotate the blade by hand while hold-

ing the handle all the way down to be sure that the blade

does not contact any part of the lower base. Re-adjust

slightly, if necessary.

CAUTION:

• After installing a new blade, always be sure that the

blade does not contact any part of the lower base when

the handle is lowered completely. Always do this with the

tool unplugged.

Adjusting the miter angle

Loosen the clamp screw on the guide fence and turn the turn

base to the position where the pointer points to the desired

angle on the miter scale. Then tighten the clamp screw firmly

to secure the turn base.

CAUTION:

• When turning the turn base, be sure to raise the handle

fully.

• After changing the miter angle, always secure the turn

base by tightening the clamp screw firmly.

1. Turn base

2. Adjusting bolt

1. Top surface ot turn base

2. Periphery of blade

3. Guide fence

002171

001540

1. Clamp screw

2. Miter scale

3. Pointer

002172

1 2 3 4 5 6 7 8 9 10 ... 32

No comments

Makita SLIDE COMPOUND SAW LS1011N Specifications Page 9