Makita SLIDE COMPOUND SAW LS1011N Specifications download pdf (Page 25)

1. Miter angle

Push the carriage toward the guide fence and tighten the

clamp screw on the turn base to secure the carriage.

Loosen the clamp screw on the guide fence which

secures the turn base. Turn the turn base so that the

pointer points to 0° on the miter scale. Then turn the turn

base slightly clockwise and counterclockwise to seat the

turn base in the 0° miter notch. (Leave as it is if the

pointer does not point to 0°.) Loosen the hex bolts secur-

ing the guide fence using the socket wrench.

Lower the handle fully and lock it in the lowered position

by pushing in the stopper pin. Square the side of the

blade with the face of the guide fence using a triangular

rule, try-square, etc. Then securely tighten the hex bolts

on the guide fence in the order from the right side.

Make sure that the pointer points to 0° on the miter

scale. If the pointer does not point to 0°, loosen the

screw which secures the pointer and adjust the pointer

so that it will point to 0°.

2. Bevel angle

(1) 0° bevel angle

Push the carriage toward the guide fence and

tighten the clamp screw on the turn base to secure

the carriage. Lower the handle fully and lock it in the

lowered position by pushing in the stopper pin.

Loosen the lever at the rear of the tool.

1. Guide fence

2. Hex bolts

002184

1. Guide fence

2. Triangular rule

002185

1. Screw

2. Miter scale

3. Pointer

002186

002187

1 ... 24 25 26 27 28 29 30 31 32

No comments

Makita SLIDE COMPOUND SAW LS1011N Specifications Page 25